运行PAC成本第二道程序时出错.(已解决) PAC成本, 异常情况, Phase, 程序, JOB

独孤彬

当运行PAC成本第二道程序:週期性成本處理(Periodic Cost Processor)时出现下面的错误日志.

请问有没有朋友遇到过,应该是下面那几个JOB的问题,但我检查了那些JOB都没发现有什么异常情况,真是怪了.忘了说明我公司用的是离散式工单.下列工单是标准的离散式工单，不可能出现工单组装料号和下阶料号相同的死循环的。但还是出现下面的错误。
烦请DX告诉解决方法.
万分感谢!!


Running from  2008/04/01 00:00:00 to 2008/04/30 00:00:00
Start Phase : 2
Start Processing Phase 2
Complete Purging Phase 2 - 5
Complete Beginning Balance Setup
Finish Processing Phase 2

Start Processing Phase 3
CSTPPLLC:calc_low_level_codes:60 A loop dependency is detected between the transactions listed below (in the plsql section)
Processing failure on phase 3.
+---------------------------------------------------------------------------+
Start of log messages from FND_FILE
+---------------------------------------------------------------------------+
Component 1135521700180 is issued for assembly 1135521600180 in job / repetitive assembly / flow schedule 12830002811-50139
Component 2135520800170 is issued for assembly 2135520700130 in job / repetitive assembly / flow schedule 12830002848-52643R2-1
Component 2135520700130 is issued for assembly 2135520800170 in job / repetitive assembly / flow schedule 12830002848-52643R2
Component 1135521600180 is issued for assembly 1135521500160 in job / repetitive assembly / flow schedule 12830002811-50138
Component 2135520700130 is issued for assembly 1135521700180 in job / repetitive assembly / flow schedule 12830002811-50146
Component 2135520800170 is issued for assembly 1135521200280 in job / repetitive assembly / flow schedule 12830002848-52643
Component 2135520800170 is issued for assembly 1135521200280 in job / repetitive assembly / flow schedule 12830002848-52653
Component 2135520800170 is issued for assembly 1135521200280 in job / repetitive assembly / flow schedule 12830002992-53645
Component 2135520800170 is issued for assembly 1135521200280 in job / repetitive assembly / flow schedule 12830003071-55962
+---------------------------------------------------------------------------+
End of log messages from FND_FILE

[ 本帖最后由 独孤彬 于 2008-8-17 00:25 编辑 ]

fannyhan

工單產生LOOP..所以成本無法計算..
看起來很像是這二張工單的問題
12830002848-52643R2-1的組裝件號為2135520800170下階用料為2135520700130
12830002848-52643R2的組裝件號為2135520700130下階用料為2135520800170

独孤彬

谢谢楼上的。确实是这个问题。
由于库存期间已经关闭。所以我直接将JOB：12830002848-52643R2-1对应的下階用料2135520700130的发料时间更改到上个月，然后运行PAC的三个程序，顺利完成，然后再把发料时间改回来。虽然会影响其成本值，但也管不了那么多了。